The switching output can be loaded with 12V / 0.5A, is short-circuit and overload-proof and of the type PNP, plus output, load grounded. 1 x intAct Battery Guard for 6,12 and 24Volt batteries order. The electronics are protected against moisture, the connection is made in the rear terminal compartment by means of a plug-in screw terminal. Battery 12V 15AH Hawker SBS15: 12,0 V, 13Ah, L: 200,0 mm, B: 77,0 mm, H: 140 mm. The switching status is indicated by an LED. The dynamic threshold detection also avoids oscillation around the switching points when switching very large loads. with which the BG automatically detects what the battery voltage (12V or 24V) of the system is, so that it does not need to be set manually. An intelligent voltage evaluation of the switching thresholds avoids faulty triggering in the event of voltage drops or peaks. The Battery Guard BG40/60/100/200 (hereafter BG) is an intelligent, fully waterproof, battery guard with expansion capabilities for an on/off switch, alarm buzzer or relay. from the starter battery) for a subsequent powerful (disconnecting) relay, which can also be used to control auxiliary consumers that are only to be activated when the battery is sufficiently charged, such as switching on an air conditioning system while the vehicle is in motion or switching a refrigerator, a cold box or a heat box to 12 V on-board operation. 1280W Load Power Built-in 100A BMS,10 Years Lifetime 4000+ Cycles, Perfect for RV Solar Energy Storage Marine Trolling motor. It generates a voltage-controlled signal (e.g. LiTime 12V 200Ah LiFePO4 Lithium Battery With 2560Wh Energy Max. However, this contact is often not accessible in the vehicle, no longer available with newer alternators, not available with a container superstructure or voltage-dependent control is generally required. If additional consumers are only to be switched on when the engine is running (the alternator supplies power) or if the on-board battery is to be charged via an isolating relay by interconnecting the on-board and starter batteries, the D+ contact of the alternator is usually used to control a relay. Control unit for recording charging operation in a 12 Volt on-board power supply (engine running).
0 Comments
Leave a Reply. |